Your StompShield cover is designed to protect your device while staying removable, clean, and easy to use.
What’s included
- 1 acrylic StompProof cover
- Hook-and-loop Velcro dots
- Rubber bumpers
Step 1: Remove the protective film
Peel off the protective film from both sides of the acrylic cover before installation.
Tip: There is a layer on the top and the underside of the acrylic.
Step 2: Locate the etched placement guides
On the underside of the cover — the side that faces your device — you’ll see lightly etched circles. These are alignment guides for the Velcro dots and rubber bumpers.
- Velcro dots go in the corner guide circles
- Rubber bumpers go in the center/middle guide circles throughout the cover
Step 3: Attach the hook dots to the cover
Take the hook side of the Velcro and apply one dot to each corner guide circle on the underside of the cover.
Make sure each hook dot is centered within its etched circle.
Step 4: Attach the rubber bumpers
Place the black rubber bumpers in the etched guide circles located in the middle/support areas of the cover.
These bumpers help:
- raise the acrylic slightly off the unit
- reduce movement
- keep debris from getting trapped underneath
- support the cover across the device
Step 5: Prepare the loop dots
Now take the loop dots and attach them directly onto the hook dots that are already installed on the cover. This will leave you with the loop dots attached to the hook dots with the adhesive side is exposed.
Step 6: Place the cover onto your device
Carefully flip the cover over and place it on top of your device.
As you lower it into place:
- line up the cover with the device
- press firmly so the loop dots adhere to the unit
- allow the Velcro locations on the cover and device to line up perfectly
Once installed, the cover can be removed and reattached as needed.
Step 7: Finished installation
Once installed, your StompProof cover should sit slightly above the surface of the device on the bumpers and Velcro support points.
This keeps the acrylic from resting directly on the unit while still protecting it from impacts, debris, and everyday floor use.
Important Notes
- Make sure the device surface is clean and dry before installation.
- The cover is designed to be removable, so you can easily take it off for cleaning or when using the device at a desk.
- Periodically inspect the Velcro and bumpers to ensure they remain clean and securely attached.