StompShield for Darkglass Anagram

Bass rigs live on dark, crowded stages where the Anagram’s big touchscreen is an easy target for a stray boot, a dropped mic stand, or a spilled drink. The StompShield is a laser-cut acrylic cover that guards the top of your Anagram without sitting on it. It mounts on hook-and-loop fasteners and rubber bumpers, so the cover stays lifted off the surface and nothing grinds against your screen or finish.

Why a standoff design matters

Many covers use magnets that pull the acrylic flat against the unit. That seems secure, but dirt, grit, and moisture get trapped between the cover and the surface. Every stomp then grinds that debris into your finish and screen. The StompShield rests on its mounts and never on your gear. There is no contact with the surface, so nothing gets ground into it.

Features

• Stays off your unit. Hook-and-loop fasteners secure the cover to the board, and rubber bumpers support it across its full span. The cover holds firm without contacting the Anagram.
• Solid support underfoot. Bumpers are placed throughout the cover to spread the load, so it stays stable when you step on it.
• 1/8" cast acrylic. It’s rigid, crystal clear, and lighter than thicker alternatives. Cast acrylic is stronger and more scratch-resistant than cheaper extruded sheet.
• Magnetic screen cover. The screen section pops off on its own, so you can reach the touchscreen mid-set without removing the whole shield.
• Knobs and footswitches stay free. Precise cutouts around all six knobs and three footswitches let you tweak parameters and switch presets as normal with the shield on.
• Use it only when you need it. The cover lifts off by the hook-and-loop fasteners, so you can leave it off for practice and programming and put it on before the show.
• Precision laser-cut. It’s cut to the exact layout of the Anagram, so the screen, knobs, and footswitches line up.

Specs

• Material: 1/8" (3mm) cast acrylic
• Mounting: hook-and-loop fasteners with rubber standoff bumpers
• Screen access: removable magnetic screen panel
• Fits: Darkglass Anagram

What’s in the box

Main StompShield cover, magnetic screen cover, hook-and-loop fasteners, rubber bumpers, and installation instructions.

StompProof is not affiliated with or endorsed by Darkglass Electronics. Anagram is a trademark of Darkglass Electronics Oy.